How to unload 12 meters tipper semi trailer?

The frame and longitudinal beam of the tipper semi trailer are welded with manganese plates. The cargo box has two kinds: dustpan and rectangle. It has the characteristics of high strength, strong lifting force, good stiffness, toughness and strong bearing capacity. So do you know how to unload 12 meters tipper semi trailer?

1, 12 meters of tip-over semi trailer unloading as far as possible to choose a flat place, if there is a slope of loading and unloading, should be along the ramp, the head to the front of the ramp below, to be commanded for loading and unloading, operation must be careful, it should be noted that the loading and unloading on the transverse slope must be prohibited.

2, 12 meters of rollover dump semi trailer unloading should start the car first, there is a retarder power switch in the cab, step down the clutch, and then open the retarder, there is a practical handle in the left side of the safe driving seat, put the handle into the rising position, gradually loosen the clutch can lift the cargo box.

3. After unloading the 12m side dump semi-trailer, the fulcrum bolts and U-shaped bolts must be checked and each bolt must be fastened one by one; After the regular inspection of each bolt, such as loose, to tighten immediately, to pay attention to whether there is loose phenomenon, to timely adjust the direction, if loose, to adjust in time.

To sum up, this is the introduction of the unloading method of the rollover dump semi-trailer. After the semi-trailer is unloaded, the car should be slightly removed from the unloading position, so that the carriage can be reset in time and the tipping lever can be locked to drive away.